100994 Hytec Hydraulic Intensifers UPC #662536377324

Part #100994 Hydraulic Intensifers

Intensifiers are used in applications where an existing low pressure hydraulic source is available. They amplify low pressure to a range better suited to workholding systems.

Intensifiers use a reciprocating pumping mechanism to generate the high pressure flow so their volume is not limited as with piston style intensifiers. This allows the intensifier to compensate for any oil consumption on the high pressure side. The outlet pressure is directly proportional to the inlet pressure. High pressure adjustment is achieved by varying the inlet pressure.

Flow from the low pressure source is directed through the intensifier to the downstream circuit. As system pressure increases, the intensifier begins to cycle and intensifies the system pressure by the ratio specified.

Models without a dump valve do not allow reverse flow so directional control must take place downstream in the high pressure circuit. Models with the dump valve allow directional control in the low pressure supply circuit. The optional directional valve manifold block has a standard Vickers C-10-4 cavity to accept a variety of manual and solenoid valves. Fitting No. 253288 can be used with part No. 100997. 

Features:

• 5,000 psi maximum
• 3.2, 4 and 5.1 ratios available
• Optional valve manifold
• Extremely compact size

IMPORTANT: Demands created by the addition of this device to an existing hydraulic system can cause fluctuations in available pressure and flow to that system. The effects of these fluctuations on the original system must be evaluated by the designer of that system.

NOTE: Approximate inlet to outlet leakage is 1 cu. in./min. Requires 10 micron nominal filtration. Hytec filter 100919 is ideal for protecting the inlet port. M24-1.5 nut included.